Two Way Alarms
Operation And Installation
Simple Installation (Recommended) · Attach the red wire ( positive wire) to a positive line which has power when everything is turned off. · Attach the black to a ground (negative wire) · Attach the yellow wire to an interior light (optional) · Use the two sided adhesive pad to attach the main engine to a place in the vehicle which is close to the boxes you wish to protect. In extreme heat areas, put a bead of silicone around the outside of the adhesive pad. Be sure to mount the unit where you can reach the Sensitivity and Code learning adjustments. · Use the adhesive pad to attach the siren to a hidden place. · Use the two sided pad to attach the antenna.
Buy Now
Simple installation remote functions · Lock- push the lock button once to arm · Unlock- push the unlock button once to disarm · Silent Lock- push the lock button twice to arm silently · Find/Light- push once to turn on light momentarily, push twice to set off alarm · Backlight Remote- push light to backlight remote · Built in clock- To set clock, push lock and unlock button simultaneously and hold clock starts flashing, to enter into set mode. Press lock button to select Hour or Minute. Press unlock button to change time. Press and hold lock and unlock buttons simultaneously to close time set mode. · Additional Remotes With built in code learning additional remotes can be added to the alarm system as a back up or as a replacement 
Buy Now
The Two Way Alarm can be adjusted for sensitivity. Take out the rubber plug ( See Picture) and using a slim blade screw driver turn the adjustment screw clockwise to make the unit more sensitive and counter clockwise to make it sell sensitive.
The Two Way Alarm has code learning mode so you can program a new remote if needed. This is done by removing the rubber plug, ( see picture) and holding the button in while pushing a button on the remote. You should hear 2 beeps. Two remotes can be programmed, but only one at a time will be recognized by the main unit. You can purchase a additional remote and program it as a back up, but it is best to leave the battery out until you need it after programming it. To program 2 remotes, hold the remote learning code button then push button on one alarm and then the other you should here 2 beeps .
Advanced Installation
While we recommend the simple installation, this is a multi purpose unit which has features which are desirable in different applications. These features give you the ability to start and stop the vehicle with the remote, and to kill the system with the remote, so the vehicle will not start even if the key is turned on. These features work well on vehicles left unattended, such as a ATV left in the woods while hunting, PWC left in a boathouse, or a motorcycle left unattended while quenching a thirst. Because of the advanced wiring we recommend that the advanced installation be done by a qualified technician. See enclosed motorcycle manual for more detail.
